Contractor GEN8000 Instruction Manual

8000W GENERATOR8000W GENERATORStock No. GEN8000/03213Instruction Manual

PAGE 108. Keep all electrical equipment clean and dry. Replace any wiring where the insu-lation is cracked, cut, abraded or otherwise degraded. Repl

5. Place the Generator as close as possible to the electrical tools and equipmentbeing powered to reduce the length of extension cords.GENERATOR SUPPO

PAGE 12GROUND CONNECTOR(8)#6AWGGROUNDING WIRE(NOT INCLUDED)GROUNDING ROD(NOT INCLUDED)FUEL TANK(30)(33)POWERSWITCH(2)

PAGE 133. Before the first use, remove the Fuel Tank Cap (33) and fill the Fuel Tank (30) withunleaded gasoline. Then, replace the Fuel Tank Cap. The

PAGE 14FUEL TANK (32)5. Turn the Engine Power Switch (2) to its "ON" position. (See Figure F.)6. Hold the Start Handle (41A) loosely and p

PAGE 15Prior to powering tools and equipment, make sure the Generator's rated voltage, and amperage capacity (120V 47AMP, 240V 23AMP) is adequate

PAGE 167. NOTE: The Generator features a 10 AMP DC Fuse (9) to protect the DC circuit incase of an overload. Should an overload occur the Fuse will b

PAGE 17damaged electrical wiring, and any other condition that may affect its safe opera-tion. If an Engine problem occurs, always have the Engine im

PARTS LISTPAGE 18NOTE: Some parts are listed and shown for illustration purposes only, and are notavailable individually as replacement parts.2

PAGE 19

PRODUCT SPECIFICATIONSPAGE 2Item Description VAC Electrical Requirements VDC Electrical Requirements Current Output: 12 VDC @ 10 AMP's Voltmete

PARTS LIST ANOTE: Some parts are listed and shown for illustration purposes only, and are notavailable individually as replacement parts.PAGE 20Oil Se

ASSEMBLY DIAGRAM APAGE 21

WIRING DIAGRAMPAGE 22

PAGE 3GENERAL SAFETY RULESWARNING!READ AND UNDERSTAND ALL INSTRUCTIONSFailure to follow all instructions listed below may result inelectric shock, fi

PAGE 47. Do not expose Generator to rain or wet conditions. Water entering agenerator will increase the risk of electric shock.8. Do not abuse the Po

PAGE 5GENERATOR USE AND CARE18. Make sure the Power Switch is in its “OFF” position and disconnect thespark plug wire before making any adjustments, c

SPECIFIC PRODUCT WARNINGS AND PRECAUTIONSPAGE 6INSTALLATION PRECAUTIONS1.2. The earth ground connection should be completed by a licensed electrician.

PAGE 79. The supporting floor/ground surface should be level, and strong enough to safelyhold the weight of the Generator. If the floor/ground surfac

MECHANICAL PRECAUTIONS1. ALWAYS make sure the Power Switch is in its "OFF" position. Disconnect thespark plug wire, and allow the Engine to

PAGE 9ELECTRICAL PRECAUTIONS1. All connections and conduits from the Generator to the load must only be in-stalled by trained and licensed electrician